Audi 100

1982-1990 of release

Repair and operation of the car

Виховання цуценя коллі

11.13. Door lock

GENERAL INFORMATION

Removal of the lock of a door

1 – draft;

2 – plug;

3 – lock

Blocking of the driving lever of the lock

1 – driving lever;

2 – assembly opening;

3 – lock lever

Mechanism of locking of a door

1 – button of blocking of the lock;
2 – handle;
3, 5, 8 – hinged connections;
4 – lock draft;
6 – draft of the lock;
7 – adjusting nut;
9 – door lock;
10 – bolt;

11 – consolidation;
12 – the screw with crosswise shliyets;
13 – cable;
14 – lock cover;
15 – lock;
16 – stopper;
17 – draft

Removal

PERFORMANCE ORDER

Release models till January, 1988.
1. To turn out the button of blocking of the lock of a door.
2. To turn off two bolts with an internal hexagon of fastening of the lock.
3. To pull out a few lock on itself and to disconnect draft from the lock drive lever.
4. To remove the lock.
Release models since January, 1988.
5. To disconnect drafts from lock levers, having wrung out a screw-driver spring holders.
6. To disconnect a cable from the lock lever.
7. To turn off two bolts and to take out the lock from the lock.

Installation

PERFORMANCE ORDER

Release models till January, 1988.
1. To install the lock drive lever vertically (at an angle 90 ° to the lock case) and to block it by means of a screw-driver through an assembly opening.
2. To connect thirst for the lock drive lever.
2. To insert the blocking lever into the plug of draft of blocking.
3. To unblock the drive lever, having taken out a screw-driver.
4. To wrap two bolts of fastening of the lock.
Release models since January, 1988.
5. To put the door lock upside-down of removal. If necessary to adjust draft length by means of an adjusting nut.