Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   + 12.1. System of electric equipment
   - 12.2. System of ignition
      + 12.2.1. Transistor system of ignition
      - 12.2.2. Electronic system of ignition
         12.2.2.1. Check of the coil of ignition
         12.2.2.2. Check of the sensor of a corner of an advancing of ignition
         12.2.2.3. Check of the sensor of frequency of rotation of a cranked shaft
         12.2.2.4. Sensor of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
         12.2.2.5. Check and replacement of the sensor of air temperature
         12.2.2.6. Check of the sensor of temperature of cooling liquid
         12.2.2.7. Switches of the mode of idling and opening of a butterfly valve
         12.2.2.8. Check of the sensor of the Hall
         12.2.2.9. Check of the control unit
      12.2.3. Contactless system of ignition of FEI
   + 12.3. Electric circuits

12.2.2.8. Check of the sensor of the Hall

GENERAL INFORMATION

Numbers of contacts of a connecting block of the control unit

PERFORMANCE ORDER

1. To disconnect the central wire of a high voltage from the distributor of ignition and to connect it to "weight".
2. To disconnect a connecting block.
3. To connect the voltmeter to extreme contacts "1" and "3", to include ignition. The voltmeter has to show tension about 9 Century. Otherwise to check conducting.
4. To shift back a protective cover from a block, to connect the voltmeter to contacts "1" and "2" and to establish a block in a nest on the ignition distributor.
5. To uncover the distributor, the runner and the antidust screen.
	6. To turn a cranked shaft of the engine so that teeth of an anchor (1) distributor did not block the sensor of the Hall (2). To include ignition. Tension has to be 4 Century.
7. To turn a cranked shaft so that one of teeth of an anchor was combined with the Hall sensor. Tension has to decrease to 0–0,5 V. Vyklyuchit ignition. If tension differs from set, to replace the Hall sensor.
	8. To connect an ohmmeter to contacts "1" and "4", then to contacts "2" and "27" and, at last, with "3" and "25". Resistance has to be equal in all cases to zero. If resistance differs from zero, means in conducting there is a break.