Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
- 6. Power supply system
   + 6.1. Power supply system of carburetor engines
   - 6.2. A power supply system of engines with fuel injection
      6.2.1. Replacement of the filtering element of the air filter
      6.2.2. Removal and installation of the air filter
      6.2.3. Replacement of the fuel filter
      6.2.4. Removal and installation of the distributor of fuel
      6.2.5. Dismantling and assembly of the reducing valve
      6.2.6. Removal and installation of the fuel accumulator
      6.2.7. Removal and installation of fuel nozzles
      6.2.8. Removal and installation of a turbocompressor
      6.2.9. Removal and installation of a fuel tank
      6.2.10. Removal and installation of the fuel pump
      6.2.11. Check of a temperature regulator
      6.2.12. Adjustment of idling of the engine
      6.2.13. Check of a starting nozzle
      6.2.14. Check of the regulator of pressure
      6.2.15. Check and adjustment of provision of a plate of the measuring instrument of a consumption of air
   + 6.3. Power supply system of the diesel engine
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment










6.2.4. Removal and installation of the distributor of fuel

PERFORMANCE ORDER
1. To reduce pressure in a power supply system (see the item 3 of subsection 6.2.2).
2. To mark and disconnect fuel-supply lines from the fuel distributor (see rice. Basic elements of system of injection of fuel), having turned off fastening bolts.
3. To unscrew three screws of fastening of the distributor and to remove the distributor. Thus to watch that from below the plunger did not drop out of the case. If the plunger incidentally dropped out, to wash out it in gasoline and to insert into the distributor case the open end down.
4. To install the distributor upside-down, having replaced a sealing ring of the case of the distributor. Before installation of the distributor to check that the plunger freely moved up-down. To zakontrit screws of fastening of the distributor paint.