Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
- 8. Running gear
- 8.1. Forward suspension bracket
8.1.1. Telescopic rack
8.1.2. Replacement of the shock-absorber
8.1.3. Removal and installation of the stabilizer of cross stability
8.1.4. Nave of a forward wheel
+ 8.2. Back suspension bracket
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Prevention
When replacing the shock-absorber the car has to stand on wheels.
| PERFORMANCE ORDER |
| 1. To take off the decorative cap closing access to a nut of the top fastening of the shock-absorber. |
| 2. To turn off a nut of the top fastening of the shock-absorber, holding a shock-absorber rod from a provorachivaniye by means of a hexagon. |
| 3. To mark the provision of washers on the top support of a rack, having led round their contour, for preservation of a corner of disorder of forward wheels. |
| 4. To turn off nuts of fastening and to remove the top support of a rack. |
| 5. Turn of a steering wheel to center a shock-absorber rod concerning the basis of the top support. |
| 6. To remove a washer and the buffer of the course of compression from a shock-absorber rod. |
| 7. Through rounds of a spring to squeeze a protective cover and to take off a protective cap. |
| 8. To turn off a nut of the lower fastening of the shock-absorber (at service stations the adaptation 2069 is used) by means of the special adaptation. |
| 9. To take out the shock-absorber up. |
|
Installation
| PERFORMANCE ORDER |
| 1. To install the shock-absorber upside-down. |
| 2. Thus to fill the top edge of a protective cover in laying of a spring, having pressed to a protective ring. |
| 3. To replace a nut of the top fastening of the shock-absorber on new and to tighten its moment 60 N · m (6,0 kgfs · l), holding thus a shock-absorber rod from a provorachivaniye by means of a hexagon. |
|
|
|