Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.1. Technical characteristics
   9.2. Steering wheel
   + 9.3. Steering column
   9.4. Steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draft
   9.7. Pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Pumping of system of the hydraulic booster of a steering
   9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

Волосінь

9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering

PERFORMANCE ORDER

1. To turn off the bringing bolt and to disconnect the bringing hose from the pump and to connect instead of it a hose with the manometer.
2. To start the engine and to leave to idle it.
3. To turn out against the stop wheels in any party, to check pressure on the manometer and at once to turn wheels in a starting position. This operation has to occupy no more than 30 with, otherwise the pump can fail. Pressure has to be 14 500–15 500 kPas (145–155 ^kgfs/cm2).
4. If pressure differs from specified, it is necessary to replace the valve of a high pressure and to execute repeated check. If pressure does not meet standard again, the pump is faulty and it needs to be replaced.