Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1. System of electric equipment
      12.1.1. Technical characteristics
      12.1.2. Safety locks, relay and control units
      + 12.1.3. Generator
      - 12.1.4. Starter Removal and installation of a starter Dismantling and assembly of a starter Check, survey and troubleshooting of details of a starter
      + 12.1.5. Lighting and light alarm system
   + 12.2. System of ignition
   + 12.3. Electric circuits Dismantling and assembly of a starter

1. To turn off nuts.
2. To remove a basic plate.
3. To turn out two vinta to uncover with laying.
4. To remove a lock ring with washers.
5. To turn off coupling bolts.
6. To uncover the party of a collector.
7. To turn off a nut and to disconnect a stator winding conclusion from the traction relay.
8. To take out the brush holder from the case, thus to wring out springs and to take out two isolated brushes from the brush holder.
9. To remove the case.
10. To turn off three bolts and to remove the traction relay from a cover. Thus the anchor of the traction relay has to remain on the drive lever.
11. To take out a rubber sealant of the lever. To remove an anchor of the traction relay from the lever.
12. To turn out a lever axis.
13. To take out an anchor from a cover from the drive. To remove the drive lever.
14. To bring down through a mandrel the holding ring towards an anchor. To remove the lock ring established under the holding ring.
15. To remove from an anchor shaft the starter drive assembled.
16. At a starter of Bosch 1,1kW to remove a reducer. To collect a starter upside-down, thus it is necessary to establish a new lock ring, and also to grease the rubbing surfaces of details.