Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
- 8. Running gear
   + 8.1. Forward suspension bracket
   - 8.2. Back suspension bracket
      8.2.1. Telescopic rack
      8.2.2. Zadny Bridge
      8.2.3. Brake drum
      8.2.4. A nave of a back wheel (model with the disk brake mechanism)
      8.2.5. Adjustment of bearings of a nave of a wheel
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

8.2.5. Adjustment of bearings of a nave of a wheel

PERFORMANCE ORDER

1. To establish an emphasis under forward wheels.

2. To raise and establish back part of the car on a support.

3. To bring down a protective cap of a nut of a nave a hammer with a rubber tip.

4. To take out the forelock and to remove a nave nut clamp.

5. To tighten a nave nut against the stop, turning thus a wheel for self-installation of bearings of a nave. Then slightly to release a nut until when the washer can be shifted by means of a screw-driver by effort of a hand. Thus is inadmissible to use a screw-driver as the lever, leaning it on a nave fillet.

6. To establish a clamp and the forelock. For coincidence of an opening in a pin under the forelock and cuts in a clamp the nut of a nave needs to be tightened only.

7. To add jellied greasing in a protective cap of a nut of a nave to two thirds of its volume and to press it into place by means of a suitable mandrel. The wrinkled and burst protective caps are subject to obligatory replacement (in avoidance of hit of dirt and moisture in a nave).