Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1. System of electric equipment
      12.1.1. Technical characteristics
      12.1.2. Safety locks, relay and control units
      - 12.1.3. Generator Removal and installation of the generator Dismantling and assembly of the generator Check, survey and troubleshooting of details of the generator Adjustment of a tension of a belt of the drive of the generator
      + 12.1.4. Starter
      + 12.1.5. Lighting and light alarm system
   + 12.2. System of ignition
   + 12.3. Electric circuits Dismantling and assembly of the generator

1. To clear the generator of dirt and dust.
2. To turn out screws of fastening and to remove the regulator napryazheniyaso the brush holder.
3. To turn off coupling bolts and to uncover the generator from the drive with a rotor.
4. To clamp slightly a rotor for polar tips in a vice and to turn off a nut of fastening of a pulley.
5. To remove a washer, a pulley and the fan with laying. To take out a spline from a rotor shaft.
6. To Vypressovat a rotor from a generator cover.
7. To turn off bolts and to uncover the bearing.
8. To Vypressovat the bearing from a generator cover.
9. To press the bearing from a rotor shaft.
10. To turn out the screw and to remove the condenser.
11. To turn out nuts and to remove washers, laying and an insulator.
12. To turn out three screws of fastening of conclusions of a winding of the stator to the vypryamitelny block and to remove the stator from a cover.
13. To turn out screws and to take out the vypryamitelny block from a cover.
14. To assemble the generator upside-down.