Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
- 6. Power supply system
   - 6.1. Power supply system of carburetor engines
      6.1.1. Replacement of the filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Check of a temperature regulator
      6.1.4. Valve check of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of the drive of an accelerator
      6.1.8. Adjustment of a cable of the drive of an accelerator
      6.1.9. Replacement of the fuel level sensor
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin purification of fuel
      6.1.12. Removal and installation of the carburetor
      + 6.1.13. Dismantling and assembly of the carburetor
      + 6.1.14. Adjustments of the Pierburg 1B3 carburetor
      + 6.1.15. Adjustments of the Pierburg 2E2 carburetor
      + 6.1.16. Adjustments of the Keihin carburetor
   + 6.2. A power supply system of engines with fuel injection
   + 6.3. Power supply system of the diesel engine
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment










6.1.8. Adjustment of a cable of the drive of an accelerator

PERFORMANCE ORDER
1. To disconnect a cable from the lever of a butterfly valve of the carburetor.
2. To establish an accelerator pedal so that the distance from a pedal against the stop on a floor was 60 mm.
3. To install the lever of the drive of a butterfly valve in the provision of idling (butterfly valves are closed) and to attach to it a cable.
4. To pull a cable and to insert a persistent bracket into the groove, next to an arm, on an adjusting tip of a cable.
5. It is possible to check adjustment, having pressed an accelerator pedal against the stop. Thus the distance between the lever of the drive of a butterfly valve and an emphasis has to be no more than 1 mm.