Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
- 6. Power supply system
   - 6.1. Power supply system of carburetor engines
      6.1.1. Replacement of the filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Check of a temperature regulator
      6.1.4. Valve check of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of the drive of an accelerator
      6.1.8. Adjustment of a cable of the drive of an accelerator
      6.1.9. Replacement of the fuel level sensor
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin purification of fuel
      6.1.12. Removal and installation of the carburetor
      + 6.1.13. Dismantling and assembly of the carburetor
      + 6.1.14. Adjustments of the Pierburg 1B3 carburetor
      + 6.1.15. Adjustments of the Pierburg 2E2 carburetor
      + 6.1.16. Adjustments of the Keihin carburetor
   + 6.2. A power supply system of engines with fuel injection
   + 6.3. Power supply system of the diesel engine
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment










6.1.12. Removal and installation of the carburetor

GENERAL INFORMATION

Inlet pipe and carburetor of the engine with a capacity of 1,8 l

1 – heater of an inlet pipe;
2 – sealing ring;
3 – laying;
4 – inlet pipe;
5 – collar;
6 – hose of heating of the carburetor;
7 – flange;
8 – carburetor;
9 – fuel supply hose;
10 – laying of an inlet pipe;
11 – sealing ring

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the battery.
2. To remove the air filter (see subsection 6.1.2).
3. To merge about a half of cooling liquid (see subitem 1-3 of subsection 4.1).
4. To disconnect from the carburetor hoses of giving and plum of cooling liquid, an electrical wiring, an accelerator cable, fuel and vacuum hoses.
5. To turn off nuts (or bolts) and to remove the carburetor from an inlet pipe. To remove laying of the carburetor.
6. To install the carburetor upside-down.