1. To disconnect a wire from the "minus" plug of the battery. |
2. To remove a cowl (cm. subitem 1-6 of subsection 11.3). |
3. To merge cooling liquid (see subitem 1-3 of subsection 4.1). |
4. To remove a radiator (see subitem 3-9 of subsection 4.6). |
5. To disconnect cooling system hoses from the engine. |
6. To uncover the distributor of ignition and a wire of a high voltage. |
7. To remove the air filter (cm. subitem 1-6 of subsection 6.1.2). |
8. On cars with the hydraulic booster of a steering to remove the pump, without disconnecting hoses, and to fix it a wire on a body. |
9. On the cars equipped with the conditioner to remove the compressor, without disconnecting a hose, and to fix it a wire on a body. |
10. To disconnect an electrical wiring from knots and elements of the electric equipment established on the engine. |
11. On the engines equipped with the carburetor to remove a hose of ventilation of a case, to disconnect a vacuum hose, to disconnect a cable of the drive of a butterfly valve, to disconnect hoses of a supply and removal of fuel from the fuel pump and the carburetor, to remove the fuel pump. |
12. On the engines equipped with system of injection of fuel to disconnect fuel supply tubes to nozzles, to disconnect vacuum hoses from the idling regulator, to remove the air duct connecting the air consumption sensor to the idling regulator. |
13. On engines with a turbo-supercharging to unfasten a cover of the air filter and to remove it together with an air duct. To remove the air duct passing from an intermediate cooler to the case of a butterfly valve. To remove the hose going from an intermediate cooler to a turbocompressor. To remove an intermediate cooler. To remove a generator air duct. To disconnect hoses of the oil heater from an oil filter. |
14. To turn off the bolt of fastening of a case of coupling to the engine located behind a coupling switching off fork. |
15. To remove a heat-insulating guard of the right arm of an engine mount. |
16. To turn off the top bolts of fastening of a case of coupling to the engine. |
17. To remove a starter (cm. subitem 1-3 of subsection 12.1.4.1). |
18. To remove the generator (see subitem 2-7 of subsection 12.1.3.1). |
19. To disconnect a reception pipe of the muffler from a final collector and from an arm on a transmission. |
20. To establish a jack under a transmission and slightly to raise a transmission. |
21. To turn off nuts of fastening of the right support of the engine to a body and the left support – to the engine. |
22. To hang out the engine by means of a waist or the winch |
23. To remove the left arm of an engine mount. |
24. To install the engine upside-down. Before installation to grease primary shaft of a transmission and an end face of an internal ring of the vyzhimny bearing of coupling with molybdenic greasing. |