Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.1. Technical characteristics
   9.2. Steering wheel
   + 9.3. Steering column
   9.4. Steering mechanism
   9.5. Adjustment of the mechanism of a steering
   9.6. Steering draft
   9.7. Pump of the hydraulic booster of a steering
   9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
   9.9. Pumping of system of the hydraulic booster of a steering
   9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment










9.2. Steering wheel

GENERAL INFORMATION

Steering column

1 – decorative slip;
2 – steering wheel;
3 – nut;
4 – nut;
5 – a block with wires;
6 – washer;
7 – spring;
8 – bearing;
9 – understeering switches;
10 – pipe;
11 – arm of a steering column;
12 – top shaft of a steering;
13 – plug;
14 – plastic plug;
15 – lower shaft of a column of a steering;
16 – collar;
17, 18, 21 – bolts;
19 – arm;
20 – the ignition switch with the anti-theft device

Prevention

On the cars completed with a safety cushion, the steering wheel can be removed only at service stations.


Removal

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the battery.
2. To establish forward wheels in the provision of the movement of the car on a straight line.
3. To remove a decorative slip and to disconnect from it a block with wires of the switch of a sound signal.
4. To mark a relative positioning of a steering wheel and a shaft of a steering column.
5. To turn off a nut of fastening of a steering wheel on so many that its end face was aflush with an end face of a shaft of a steering column.
6. Shaking for spokes, with a force to pull on itself a steering wheel so that it descended from shliyets of a steering shaft. To turn off finally a nut and to remove a washer and a steering wheel.

Installation

PERFORMANCE ORDER
1. Before installation to check that forward wheels were in the provision of the movement of the car on a straight line and the lever of the switch of indexes of turn was in the neutral family way. Thus the rychazhok of shutdown of indexes of turn has to be sent to the left side.
2. To establish a steering wheel on a shaft according to earlier made tag.
3. To establish a washer and to wrap a fastening nut the moment of 40 N · m (4,0 kgfs · м).
4. To insert coal contact with a wire into a nave of a steering wheel.
5. To connect a block with a wire to a decorative slip and to establish an overlay for a steering wheel.
6. To check distance from a casing of a steering wheel to a casing of understeering switches which has to be equal 3 mm. If this distance differs from specified, to weaken fastening of understeering switches through the opening located from below in a casing of understeering switches. To expose the demanded distance and to fix understeering switches.
7. To make a trial trip. At the movement of the car on a straight line of a spoke of a steering wheel have to be located horizontally. Otherwise to remove a steering wheel and to establish it anew.