Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
9.1. Technical characteristics
9.2. Steering wheel
+ 9.3. Steering column
9.4. Steering mechanism
9.5. Adjustment of the mechanism of a steering
9.6. Steering draft
9.7. Pump of the hydraulic booster of a steering
9.8. Check of pressure of forcing of the pump of the hydraulic booster of a steering
9.9. Pumping of system of the hydraulic booster of a steering
9.10. Driving belt of the pump of the hydraulic booster
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. To slow down the car the parking brake and to establish an emphasis under back wheels. |
| 2. To weaken two bolts of fastening of thirsts for a gear lath (to cm. rice. Steering mechanism). Thus the car has to stand on wheels in order to avoid damage of a gear lath of the mechanism of a steering. |
| 3. To weaken an inhaling of bolts of fastening of a wheel. |
| 4. To raise and establish forward part of the car on a support. |
| 5. Finally to turn off bolts of fastening and to remove a wheel. |
| 6. To turn off a nut of fastening of a tip with the spherical hinge. |
| 7. To Vypressovat a finger of the spherical hinge from the rotary lever. It is recommended to be done by a stripper. |
| 8. Finally to turn off bolts of fastening and to remove draft or with a clamping plate. |
| 9. For replacement of a tip of steering draft to weaken a lock-nut and to turn off a tip, considering thus number of turns in order that at assembly to establish a tip in the demanded situation. |
|
Survey and troubleshooting of details of steering draft
| PERFORMANCE ORDER |
| 1. Attentively to examine steering draft. The worn-out and deformed drafts are not under repair and are subject to obligatory replacement. |
| 2. If the antisplash cover of the spherical hinge has cracks or rubber lost elastic properties, a cover to replace. |
| 3. If the spherical hinge has notable radial and axial side plays (it is checked at the established draft on the car) or the tip has a side play, the tip with the spherical hinge needs to be replaced. |
|
Installation
| PERFORMANCE ORDER |
| 1. To wrap a tip on the carving coupling on the number of turns counted at removal. |
| 2. When replacing steering draft to expose length of new draft by means of the carving coupling, equal to length of old draft, and to record lock-nuts. |
| 3. To establish draft and a new clamping plate on an arm and to wrap fastening bolts, without tightening. |
| 4. To press a finger of the spherical hinge in the rotary lever and to tighten a new nut the moment of 60 N · m (6,0 kgfs · м). |
| 5. To establish a wheel and to acquire bolts of its fastening. |
| 6. To lower the car on the earth and to tighten finally bolts of fastening of a wheel the moment of 110 N · m (11,0 kgfs · м). |
| 7. Finally to tighten bolts of fastening of thirsts for a gear lath the moment of 60 N · m (6,0 kgfs · м). To bend short moustaches of a clamping plate. |
| 8. To check a convergence of wheels for service stations. |
|
|
|