Audi 100

1982-1990 of release

Repair and operation of the car



Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1. System of electric equipment
      12.1.1. Technical characteristics
      12.1.2. Safety locks, relay and control units
      + 12.1.3. Generator
      + 12.1.4. Starter
      - 12.1.5. Lighting and light alarm system
         12.1.5.1. Replacement of a lamp of a headlight
         12.1.5.2. Replacement of a lamp of dimensional light
         12.1.5.3. Removal and installation of a headlight
         12.1.5.4. Adjustment of light of headlights
         12.1.5.5. Replacement of a lamp of the index of turn
         12.1.5.6. Removal and installation of the index of turn
         12.1.5.7. Replacement of a lamp of a fog light
         12.1.5.8. Adjustment of light of fog lights
         12.1.5.9. Replacement of lamps of a back lamp on a wing
         12.1.5.10. Replacement of lamps of a back lamp on a trunk lid
         12.1.5.11. Replacement of a lamp of a lamp of illumination of registration plate
         12.1.5.12. Replacement of a lamp of a lamp of illumination of a luggage carrier
         12.1.5.13. Replacement of a lamp of a plafond of illumination of salon
         12.1.5.14. Replacement of a lamp of a plafond of a directional light
         12.1.5.15. Removal and installation of a combination of devices
         12.1.5.16. Check of a voltage stabilizer
         12.1.5.17. Removal and installation of the relay breaker of indexes of turn
         12.1.5.18. Check of the switch of light of a backing
         12.1.5.19. Check of the sensor of the index of temperature of cooling liquid
         12.1.5.20. Verification of the index of level of fuel
         12.1.5.21. Adjustment of the index of level of fuel
         12.1.5.22. Removal and installation of a screen wiper of a windshield
   + 12.2. System of ignition
   + 12.3. Electric circuits


12.1.5.17. Removal and installation of the relay breaker of indexes of turn
GENERAL INFORMATION

Relay breaker of indexes of turns

1 – holder of the relay;

2 – relay breaker;

3 – connecting block

Removal and installation

PERFORMANCE ORDER
1. To remove a combination of devices (see subsection 12.1.5.15).
2. To disconnect from the block relay with wires. To take out the relay from a nest. On release models since January, 1988 it is necessary to unbend previously the holder.
3. To install the relay breaker upside-down.