Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1. System of electric equipment
      12.1.1. Technical characteristics
      12.1.2. Safety locks, relay and control units
      + 12.1.3. Generator
      + 12.1.4. Starter
      - 12.1.5. Lighting and light alarm system
         12.1.5.1. Replacement of a lamp of a headlight
         12.1.5.2. Replacement of a lamp of dimensional light
         12.1.5.3. Removal and installation of a headlight
         12.1.5.4. Adjustment of light of headlights
         12.1.5.5. Replacement of a lamp of the index of turn
         12.1.5.6. Removal and installation of the index of turn
         12.1.5.7. Replacement of a lamp of a fog light
         12.1.5.8. Adjustment of light of fog lights
         12.1.5.9. Replacement of lamps of a back lamp on a wing
         12.1.5.10. Replacement of lamps of a back lamp on a trunk lid
         12.1.5.11. Replacement of a lamp of a lamp of illumination of registration plate
         12.1.5.12. Replacement of a lamp of a lamp of illumination of a luggage carrier
         12.1.5.13. Replacement of a lamp of a plafond of illumination of salon
         12.1.5.14. Replacement of a lamp of a plafond of a directional light
         12.1.5.15. Removal and installation of a combination of devices
         12.1.5.16. Check of a voltage stabilizer
         12.1.5.17. Removal and installation of the relay breaker of indexes of turn
         12.1.5.18. Check of the switch of light of a backing
         12.1.5.19. Check of the sensor of the index of temperature of cooling liquid
         12.1.5.20. Verification of the index of level of fuel
         12.1.5.21. Adjustment of the index of level of fuel
         12.1.5.22. Removal and installation of a screen wiper of a windshield
   + 12.2. System of ignition
   + 12.3. Electric circuits


12.1.5.8. Adjustment of light of fog lights

GENERAL INFORMATION

Screen marking for adjustment of fog lights


PERFORMANCE ORDER
1. To mark the screen definitely, thus to put the line of the centers of headlights of M on the screen at distance h equal to height of an arrangement of the centers of fog lights over floor level. The distance of h needs to be measured on the equipped car with the additional weight equal to 70 kg, on the middle of a back seat. The fuel tank has to be filled.
2. The distance X from the center headlights to the middle of the car is measured on the car.
3. To check and if necessary to finish to rated pressure in tires.
4. To install the car on a horizontal platform perpendicular to the screen at distance of 10 m. Thus the longitudinal plane of symmetry of the car has to pass across the line 0 on the screen.
5. To include fog lights.
6. To regulate the direction of a light spot for each fog light separately. To close other headlight during adjustment opaque material (or to put on a protective cap).
7. Turning the adjusting screw, to expose headlights so that the center of a light bunch was on crossing of the N and A lines (B) (light of fog lights is regulated only on height).