Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   - 12.1. System of electric equipment
      12.1.1. Technical characteristics
      12.1.2. Safety locks, relay and control units
      + 12.1.3. Generator
      + 12.1.4. Starter
      - 12.1.5. Lighting and light alarm system
         12.1.5.1. Replacement of a lamp of a headlight
         12.1.5.2. Replacement of a lamp of dimensional light
         12.1.5.3. Removal and installation of a headlight
         12.1.5.4. Adjustment of light of headlights
         12.1.5.5. Replacement of a lamp of the index of turn
         12.1.5.6. Removal and installation of the index of turn
         12.1.5.7. Replacement of a lamp of a fog light
         12.1.5.8. Adjustment of light of fog lights
         12.1.5.9. Replacement of lamps of a back lamp on a wing
         12.1.5.10. Replacement of lamps of a back lamp on a trunk lid
         12.1.5.11. Replacement of a lamp of a lamp of illumination of registration plate
         12.1.5.12. Replacement of a lamp of a lamp of illumination of a luggage carrier
         12.1.5.13. Replacement of a lamp of a plafond of illumination of salon
         12.1.5.14. Replacement of a lamp of a plafond of a directional light
         12.1.5.15. Removal and installation of a combination of devices
         12.1.5.16. Check of a voltage stabilizer
         12.1.5.17. Removal and installation of the relay breaker of indexes of turn
         12.1.5.18. Check of the switch of light of a backing
         12.1.5.19. Check of the sensor of the index of temperature of cooling liquid
         12.1.5.20. Verification of the index of level of fuel
         12.1.5.21. Adjustment of the index of level of fuel
         12.1.5.22. Removal and installation of a screen wiper of a windshield
   + 12.2. System of ignition
   + 12.3. Electric circuits


12.1.5.22. Removal and installation of a screen wiper of a windshield

GENERAL INFORMATION

Windshield screen wiper

1 – brush;
2 – brush lever;
3 – cap;
4 – nut;
5 – spring washer;
6 – arm;
7 – draft of the drive;
8 – lever;
9 – bolt;
10 – screen wiper electric motor;
11 – windshield washer jet;
12 – valve;
13 – arm of hoses of a washer;
14 – windshield washer electric motor;
15 – windshield washer reservoir;
16 – the water level sensor in a tank;
17 – bolt

PERFORMANCE ORDER
1. To open a cowl.
2. To disconnect a wire from the "minus" plug of the battery.
3. To pick up a screw-driver and to remove protective caps from screen wiper levers.
4. To turn off not till the end (not to spoil a carving on rollers) nuts of fastening of levers of a screen wiper. By means of flat-nose pliers to pull off both levers from shlits of rollers of the mechanism of a screen wiper and, having turned off finally nuts, to remove levers.
5. To remove the protection cover.
6. To disconnect wires from the screen wiper electric motor.
7. To turn off on one bolt of fastening from each party of levers of the mechanism of a screen wiper.
8. To disconnect a bolt of fastening of an arm and to remove the screen wiper mechanism assembled.
9. To establish a screen wiper upside-down. Thus a bolt of fastening of an arm to tighten the moment of 4 N · m (0,4 kgfs · l), and bolts of fastening of support – the moment of 7 N · m (0,7 kgfs · м).
10. To install levers of a screen wiper so that brushes at rest were parallel to a tangent to the line of a contour of a windshield.