| 1. To open a luggage carrier and to take out a floor rug. |
| 2. To turn out three screws and to uncover the hatch to get access to the fuel level sensor. |
| 3. To disconnect a block with wires from the fuel level sensor. |
| 4. To install the additional resistor with a resistance of 544 Ohms between contacts of a block. Thus the arrow of the index of level of fuel in a combination of devices has to be in the beginning of a scale (an empty tank). |
5. To replace the additional resistor with the additional resistor with a resistance of 60 Ohms.
In this case the arrow of the device has to deviate in the end of a scale (a full tank). |
| 6. Both extreme provisions of an arrow are designated on a scale by two points (a device error). The arrow has to be between points in the beginning and the end of a scale. |
| 7. If it does not occur, it is necessary to adjust the provision of an arrow the screw located under the device dial. If the index does not manage to be adjusted, it needs to be replaced. |