Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   + 12.1. System of electric equipment
   - 12.2. System of ignition
      + 12.2.1. Transistor system of ignition
      - 12.2.2. Electronic system of ignition
         12.2.2.1. Check of the coil of ignition
         12.2.2.2. Check of the sensor of a corner of an advancing of ignition
         12.2.2.3. Check of the sensor of frequency of rotation of a cranked shaft
         12.2.2.4. Sensor of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
         12.2.2.5. Check and replacement of the sensor of air temperature
         12.2.2.6. Check of the sensor of temperature of cooling liquid
         12.2.2.7. Switches of the mode of idling and opening of a butterfly valve
         12.2.2.8. Check of the sensor of the Hall
         12.2.2.9. Check of the control unit
      12.2.3. Contactless system of ignition of FEI
   + 12.3. Electric circuits


12.2.2.4. Sensor of a corner of an advancing of ignition, frequency of rotation of a cranked shaft

GENERAL INFORMATION

Suspension bracket of connecting blocks on an arm

1 – ignition advancing corner sensor block; black color;

2 – block of the sensor of frequency of rotation of a cranked shaft; gray color;

3 – detonation sensor block; red color

Check of a gap between the sensor of a corner of an advancing of ignition and a flywheel

1 – bolt of fastening of an arm;
2 – probe;
3 – ignition advancing corner sensor;
4 – sensor of frequency of rotation of a cranked shaft;
5 – arm of fastening of sensors;
6 – flywheel

Check of a gap between the sensor of frequency of rotation of a cranked shaft and a flywheel

1 – probe;

2 – sensor of frequency of rotation of a cranked shaft;

3 – flywheel;

4 – protective cap

Removal and installation

PERFORMANCE ORDER
1. To disconnect blocks.
2. To turn off a bolt and to remove an arm with sensors.
3. To remove transmission to get access to an engine flywheel.
4. To turn a cranked shaft so that the pin on a flywheel appeared in cut under the sensor.
5. To establish an arm with the sensor on a place and the probe to measure a gap between a pin of a flywheel and the sensor of a corner of an advancing of ignition and a gap between the sensor of frequency of rotation of a cranked shaft and a flywheel.
6. The gap between a pin and the sensor of a corner of an advancing of ignition has to be 0,45–1,25 mm, and between a flywheel and the sensor of frequency of rotation – 0,51–1,24 mm.
7. If the measured gaps differ from specified, to replace an arm of sensors. It is also possible to enclose laying for increase in gaps or to proshlifovat an arm for their reduction.