Audi 100

1982-1990 of release

Repair and operation of the car

Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
- 7. Transmission
   + 7.1. Coupling
   + 7.2. Mechanical drive of switching off of coupling
   + 7.3. Hydraulic drive
   - 7.4. Transmission
      + 7.4.1. Four-speed transmission of type 014
      + 7.4.2. Five-speed transmission of type 013 or 093
      - 7.4.3. Five-speed transmission of types 016 and 012
         7.4.3.1. Removal and installation of a transmission
         7.4.3.2. Dismantling of a transmission
         7.4.3.3. Primary shaft
         7.4.3.4. Dismantling and assembly of a secondary shaft
         7.4.3.5. Assembly of a transmission
      + 7.4.4. Mechanism of management of gear shifting of KP of 016 type
      + 7.4.5. Automatic transmission
   + 7.5. Drive of forward wheels
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

7.4.3.1. Removal and installation of a transmission

PERFORMANCE ORDER

1. To disconnect a wire from the "minus" plug of the battery.

2. To remove the air filter (see subsection 6.1.2).

3. To turn off the top bolts of fastening of a transmission to the engine.

4. To disconnect a speedometer drive cable from a transmission.

5. To beat out a pin of fastening of the working cylinder of the drive of coupling from a coupling case.

6. To remove the working cylinder of the drive of coupling and to put it aside, without disconnecting from it a hose.

7. To raise a little power unit a waist or the winch.

8. To disconnect a reception pipe of the muffler from a final collector and an arm of a transmission.

9. To remove a heat-insulating guard of a cover of the internal CV JOINT of the right half shaft.

10. To turn off bolts of fastening and to disconnect drives of forward wheels from flanges of half shafts.

11. To disconnect electricity cables from a transmission.

12. To remove adjusting draft from two spherical fingers.

13. To disconnect draft of gear shifting from a spherical finger of the lever on a transmission.

14. To remove a spring bracket and to disconnect jet draft from a pin on a transmission.

15. To turn off the lower bolts of fastening of a case of coupling and to remove a coupling case guard.

16. To remove heat-insulating guards from a beam of a forward suspension bracket.

17. To raise a few transmission.

18. To turn off nuts of bolts of fastening of arms of a box to a beam of a forward suspension bracket.

19. To turn off a nut of fastening and to remove the right arm of a transmission.

20. To shift carefully a transmission back, having brought its primary shaft out of coupling. Then to lower a transmission and to take out it from under the car.

21. To establish a transmission upside-down. Before installation to clear and grease vents of primary shaft with graphite greasing, and also to put the internal ends of half shafts on a beam of a forward suspension bracket.