Audi 100

1982-1990 of release

Repair and operation of the car




Audi 100
+ 1.1. Governing bodies and devices
+ 2. Technical characteristics
- 3. Engines
   + 3.1. Four-cylinder engines
   - 3.2. Five-cylinder engines
      3.2.1. Removal and installation of the engine
      - 3.2.2. Dismantling and assembly of the engine
         3.2.2.1. Removal and installation of a head of the block of cylinders
         3.2.2.2. Adjustment and tension of a belt of the drive of a camshaft
         3.2.2.3. Survey, troubleshooting and repair of details of a head of the block
         3.2.2.4. Removal of a camshaft and pushers of valves
         3.2.2.5. Installation of a camshaft and pushers of valves
         3.2.2.6. Removal and installation of valves
         3.2.2.7. Dismantling and assembly of the drive of a camshaft
         3.2.2.8. Removal and installation of a flywheel
         3.2.2.9. Removal and installation of an oil case
         3.2.2.10. Removal, check and installation of the oil pump
         3.2.2.11. Replacement of epiploons of a cranked shaft
         3.2.2.12. Cranked shaft and shatunno-piston group
   + 3.3. Diesel engine
+ 4. Cooling system
+ 5. Exhaust system
+ 6. Power supply system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment










3.2.2.5. Installation of a camshaft and pushers of valves

PERFORMANCE ORDER
1. To grease pushers 19 (see rice. Head of the block of cylinders, camshaft and valves), cams and necks of a camshaft 18th engine oil.
2. To establish adjusting washers if they are, an inscription down in pushers.
3. To establish pushers 19 on the places according to earlier made marking.
4. To establish a camshaft 18 on bearings so that cams of the 1st cylinder were directed to pushers.
5. To establish covers of 15 bearings on the places. To wrap nuts of the 17th fastening of covers of bearings No. 2 and 4 and to tighten them on a diagonal before fixing of a camshaft in bearings.
6. To wrap nuts of bearings No. 1 and 3.
7. To tighten all nuts on a diagonal the moment of 20 N · m (2,0 kgfs · l)
8. To oil an epiploon engine and by means of a mandrel to press aflush with a bolt head surface.
9. To establish a spline 14, to put on a camshaft a cogwheel 11.
10. To twirl a bolt 12 with a washer and to tighten the moment 80 N · m (8,0 kgfs · м).