| 1. To remove a head of the block of cylinders (see subitem 1-12 of subsection 3.2.2). |
| 2. To turn off a bolt 12 (see rice. The head of the block of cylinders, a camshaft and valves) and to remove a cogwheel 11 from a camshaft 18. To take out a spline 14. |
| 3. To turn off one of bearing No. 2 cover nuts on two turns, considering from the camshaft drive, then to turn off a bearing No. 4 nut, opposite on a diagonal, on two turns. To turn off other nut of the bearing No. 2 and bearing No. 4 on two turns. To turn off nuts in that order until they turn away completely. |
| 4. Similarly to turn off nuts of bearings No. 1 and 3. |
| 5. To uncover 15 bearings. |
| 6. To take out a camshaft 18 |
| 7. To remove an epiploon 13. |
| 8. To remove pushers of 19 valves, previously having marked them number of the valve. If the drive of valves with adjusting washers, each washer has to be stored with the pusher. Hydraulic pushers store turned by top down. |
| 9. Survey and troubleshooting of a camshaft and hydropushers are carried out the same as on the four-cylinder engine (see subsection 3.1.2.3, subsection 3.1.2.4). |