| 1. Evenly to turn out bolts of fastening of a flywheel on 1–2 turns. |
| 2. To turn out bolts and to remove a flywheel from a cranked shaft. At removal of a driving disk it should be noted an arrangement of laying. |
| 3. To establish a flywheel or a driving disk upside-down. Before installation to apply sealant on a carving of bolts. To tighten bolts the moment of 100 N · m (10,0 kgfs · м). If replaced a driving disk, it is necessary to check and if it is necessary, to adjust its situation. The distance from a back wall of the block of cylinders to an adjusting surface of the transformer on a driving disk has to be from 30,5 to 32,1 mm. It is possible to adjust the provision of a driving disk, having established between it and a cranked shaft laying. |
|