| 1. To grease cams and necks of a camshaft and pushers with engine oil. |
| 2. To establish in pushers 7 adjusting washers by the 8th inscription down if they were taken out (see rice. Head of the block of cylinders, camshaft and valves). |
| 3. To establish pushers into place according to earlier made marking. |
| 4. To lay a camshaft on bearings so that cams of the 1st cylinder were turned to pushers. |
| 5. To establish covers of 10 bearings according to earlier made tags. To put on a diagonal the clamps of covers of the 2nd and 4th bearings before fixing of a camshaft in bearings. |
| 6. To put the clamps of covers of the 1, 3 and 5 bearings. After that to tighten all nuts on a diagonal the moment of 20 N · m (2,0 kgfs · м). |
| 7. To oil an epiploon of the 20th engine and to press it by means of a mandrel aflush with a surface of a head of the 19th block of cylinders. |
| 8. To establish a spline 11 and a cogwheel 12 on a camshaft. |
| 9. To wrap a bolt 14 with a washer 13 and to tighten the moment 80 N · m (8,0 kgfs · м). |